strompi3 not responding

978 views
0 Comments

I set the strompi3 on my Pi3B+ to wide/battery. Yesterday I tried to flash the 1.4 firmware but the strompi is not responding at all.
When I try to flash the firmware stm32flash returns „Can not Init“ or something similar. The serial console returns nothing after typing in „startstrompiconsole“. Nonetheless the LED(s) on the strompi3 are on and the battery is beeing charged.
Any suggestions?

Answered question

7 Answers

Jarek (Joy-IT) (anonymous) 0 Comments

Hi Christian,
one question beforehand: After the finished firmware flash, did you changed back the Firmware Mode Jumper to its off position?
So the it behaves in it’s normal operation setting like you’ve described and cannot init the flas procedure in the Flashmode?
Best Regards,
Jarek

Answered question
christian (anonymous) 0 Comments

Addition:
When I power the strompi3 with mUSB only (No wide Input, no USB power at Rasperry Pi) the wide LED is lid at the strompi3. The Raspi is not starting in this case.

Answered question
Write your answer.