Resolution of Alarm-Time and PowerOff-Alarm-Time only in minutes?

535 views
0 Comments

Hi.
I’m currently working with firmware version 1.7 using strompi-mode 3.
It is my goal to ensure that after loss of the primary power source the Raspberry Pi shuts down and the StromPi as well a short time after that. I fear that if there happens a PowerBack event after the RaspberryPi has begun to shutdown the StromPi does not. In this situation the re-attching of the primary power source does not boot the RasperryPi.
I assume that setting a PowerOff-Alarm-Time in the near future would ensure the powering off of the StromPi. BUT I can see that the PowerOff-Alarm-Time does not take seconds? Is that an error in the documentation? Why would it not be possbile to set a PowerOff-Alarm-Time with a resolution of 1 second?
Overall, is my way of tackling the problem stringent? As the documentation was rather rudimentary this has been my approach so far.
Regards, Armin

Answered question

21 Answers

Armin (anonymous) 0 Comments

Hi Jarek, thanks for your answer.
Till now the described behaviour did not occur again. I will keep you posted.
One more question: Is there a way to get the current configuration of the StromPi including my special values that are being set with ids 25 and 26 with command set-config? Is there a get-config?
Best regards, Armin

Answered question
You are viewing 1 out of 21 answers, click here to view all answers.
Write your answer.